Dell Active Fabric Manager Guía de usuario descargar pdf (Pagina 95)

3. Pre-deployment - Step 1c: VLT VLAN Configuration

4. Pre-deployment – Step 1d: Port Channel Configuration

5. Pre-deployment – Step 1e: Downlink Port Configuration

Pre-deployment – Step 1a: Fabric link Configuration

Before you begin, review the Using the Pre-Deployment Wizard and Pre-deployment Wizard: Introduction sections.

To configure the links that connect the leaves and spines for a Layer 3 distributed core fabric or the links that connect

the core, access, and aggregation switches for a Layer 3 with Resiliency (Routed VLT) fabric using the OSPF routing

protocol, use the Fabric link Configuration screen. The Port Bandwidth (a read-only field) is automatically determined by

the selected fabric type and fabric oversubscription ratio. To automate the pre-deployment process, AFM automatically

populates the starting IP address range/prefix, loop IP address/prefix based on the fabric design, and sets the area ID

for OSPF to 0. Review these settings. You can modify the IP address range and loopback address. The start prefix for

both types of addresses must be from 8 to 29 and the loopback prefix from 8 to 26.

For information about how to configure a Layer 2 VLT Fabric Interlink Configuration, see Pre-deployment – Step 1: VLT

Fabric Interlink Configuration

Important: The area ID for the interconnect link must not be the same as the area ID for the uplink.

To configure the Fabric Link Configuration for a Layer 3 distributed core fabric:

1. Navigate to the Network >

Fabric Name

> Configure and Deploy screen.

2. From the Deploy Fabric pull-down menu, select the Pre-Deployment Configuration option.

The Introduction screen displays.

3. Review the Introduction screen and gather the useful information to prepare your fabric for deployment.

4. Click the Next button.

The Fabric Link Configuration screen displays.

5. In the Start IP Address Range/Prefix area, enter the starting IP address and prefix.

The prefix must be from 8 to 29.

6. In the Loopback IP Address Range/Prefix area, enter the loopback address range and prefix.

The prefix must be from 8 to 26.

7. In the Area ID field, use the default setting of 0 or enter the area ID.

The area ID is a value from 0 and 65535. The uplinks or interlinks must be in area 0 for OSPF.

Pre-deployment – Step 1b: Uplink Configuration

The Uplink Configuration screen for a Layer 3 and Layer 3 with Resiliency (Routed VLT) fabric displays the port

bandwidth and the number of specified ports (read-only fields) entered on the Bandwidth and Port Count screen. To

configure the uplink protocol for the edge port uplinks to the WAN, use the Uplink Configuration screen. For information

about for a uplinks for a Layer 3 distributed core fabric, see Distributed Core Terminology.

NOTE: When the Open Shortest Path First (OSPF) is selected for both uplinks and interlinks, one of uplinks or

interlinks must be in area 0.

To configure the uplink protocol for the edge port uplinks to the WAN for a Layer 3 distributed core fabric:

1. Navigate to the Network >

Fabric Name

> Configure and Deploy screen.

2. From the Deploy Fabric pull-down menu, select the Pre-deployment Configuration option.

3. Navigate to the Uplink Configuration screen.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 178 179

Comentarios a estos manuales

Sin comentarios

Dell Active Fabric Manager Guía de usuario Pagina 95

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Dell Active Fabric Manager