Dell 3348 - PowerConnect Switch - Stackable Guía de usuario Pagina 239

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 378
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 238
Configuring Switch Information 239
3 Select an interface in the Copy Parameters from field.
4 Select the interfaces to which the GARP Timers information is copied in the Copy To
fields.
Defining GARP Timers Using CLI Commands
The following table summarizes the equivalent CLI commands for defining GARP timers
as displayed in the GARP Timers page.
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e8
Console (config-if)# garp timer leave 900
Configuring the Spanning Tree Protocol
The Spanning Tree Protocol (STP) provides a single path between end stations on a Layer 2
network, thereby eliminating loops.
Loops occur when alternate routes exist between hosts. Loops in an extended network may
cause bridges to forward traffic indefinitely, resulting in increased traffic and a reduction in
network performance. To open the Spanning Tree page:
•Click Switch > Spanning Tree in the Tree View. The Spanning Tree page opens.
CLI Command Description
garp timer {join | leave |
leaveall} timer_value
Sets the GARP application join, leave, and
leaveall GARP timer values.
Vista de pagina 238
1 2 ... 234 235 236 237 238 239 240 241 242 243 244 ... 377 378

Comentarios a estos manuales

Sin comentarios