Dell 3348 - PowerConnect Switch - Stackable Guía de usuario Pagina 283

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 378
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 282
Configuring Switch Information 283
IGMP Snooping Status—Indicates if IGMP snooping is enabled on the device. The
possible field values are:
Enabled—Enables IGMP snooping on the specific VLAN.
Disabled—Disables IGMP snooping on the specific VLAN. This is the default
value.
Enabling bridge multicast filtering on the device:
1 Open the Multicast Global Parameters page.
2 Select Enable in the bridge multicast filtering field.
3 Click Apply Changes. Bridge Multicast is enabled on the device.
Enabling IGMP snooping on the device:
1 Open the Multicast Global Parameters page.
2 Select Enable in the IGMP Snooping Status field.
3 Click Apply Changes. IGMP snooping is enabled on the device.
Enabling Multicast Forwarding and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling multicast
forwarding and IGM snooping as displayed in the Multicast Support page.
The following is an example of the CLI commands:
Console (config)# bridge multicast filtering
Console (config)# ip igmp snooping
CLI Command Description
bridge multicast filtering Enables filtering of multicast addresses.
ip igmp snooping Enables Internet Group Management
Protocol (IGMP) snooping.
Vista de pagina 282
1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 377 378

Comentarios a estos manuales

Sin comentarios