Dell OPENVIEW NNM SE 1.2 Guía para resolver problemas descargar pdf (Pagina 143)

support.dell.com Error Messages A-5

NBFSM NGBRSTATE (2) An error occurred

in the neighbor

Finite State.

Check the neighbor’s state

with the

nbrStateShow

command.

If the state is not

NB_ST_FULL, force a state

change with the

portDisable

command fol-

lowed by

portEnable

After a few seconds, if the

state is not NB_ST_FULL,

reboot both the local and

remote switches.

UCAST ADDPATH (1) A static path con-

figuration failed.

Check command

parameters.

RELICPDB (2) The path selec-

tion task received

an E_Port SCN,

but the port was

already ISL.

Run the

ucastAllShow

command. Contact cus-

tomer support.

SPFCOST(3) An error occurred

with computing

the unicast path

tree.

Run the

LSDAllShow

com-

mand. Contact customer

support.

MQ QREAD (1) A task was

unable to receive

a message.

Run the command

show

with the ID of

the queue reported in the

error. Contact customer

support.

QWRITE (1) A task was not

able to post a

message on a

queue.

See “MQ-QWRITE Error”

found later in this chapter for

more information.

SYS NOMEM (1) The system’s

memory is

exhausted.

Reboot the switch. Contact

customer support.

SYSCALL (2) A system call into

VxWorks failed.

Reboot the switch. Contact

customer support.

TIMERS ENQFAIL (1) An error occurred

while setting a

timer.

Reboot the switch. Run the

commands

actTimersShow

and

timerShow <timer ID>

Contact customer support.

Table A-1. Errors

(continued)

Module

Error

Severity Explanation Action

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 155 156

Comentarios a estos manuales

Sin comentarios

Dell OPENVIEW NNM SE 1.2 Guía para resolver problemas Pagina 143

Comentarios a estos manuales

Relacionado con productos y manuales para Los conmutadores de red Dell OPENVIEW NNM SE 1.2