Dell OPENVIEW NNM SE 1.2 Guía para resolver problemas descargar pdf (Pagina 88)

4-26 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide

stat_ftx Number of frames transmitted from the port.

stat_frx Number of frames received by the port.

stat_c2_frx Number of Class 2 frames received.

stat_c3_frx Number of Class 3 frames received.

stat_lc_rx Number of link control frames received.

stat_mc_rx Number of multicast frames received.

stat_mc_to Number of timeouts reported for multicast frames. A single

frame could cause this counter to increment if it timed out for

each multiple destination.

stat_mc_tx Number of multicast frames transmitted.

tim_rdy_pri The amount of time (measured in proprietary ticks) that R_RDY

transmission has higher priority than frame transmission.

tim_txcrd_z Time that this port cannot transmit frames due to a transmit

buffer-to-buffer credit of zero.

er_enc_in Received data: the number of 8b/10b encoding errors that have

occurred inside frame boundaries. This counter is generally a

nonzero value, although occasional errors may occur on a normal

link and give a zero result. (Minimum compliance with the link bit

error rate specification on a link continuously receiving frames

would cause approximately one error every 20 minutes.)

er_crc Received frames: the number of CRC errors detected.

er_trunc Received frames: the number of frames that were shorter than

the minimum Fibre Channel frame size (for example, a header

with no payload).

er_toolong Received frames: the number of frames that were longer than

the maximum Fibre Channel frame size (for example, a header

with a 2,112-byte payload).

er_bad_eof The number of frames received with a badly formed end-of-

frame.

er_enc_out Receive link: the number of 8b/10b encoding errors recorded

outside frame boundaries. This number may become nonzero

during link initialization but indicates a problem if it increments

faster than the allowed link-bit error rate (approximately once

every 20 minutes).

er_disc_c3 Receive link: the number of Class 3 frames discarded. Class 3

frames can be discarded due to timeouts or invalid/unreachable

destinations. This quantity could increment at times during nor-

mal operation but might be used for diagnosing problems in

some situations.

Table 4-14. portStatsShow Command Field Descriptions

(continued)

Field Description

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 155 156

Comentarios a estos manuales

Sin comentarios

Dell OPENVIEW NNM SE 1.2 Guía para resolver problemas Pagina 88

Comentarios a estos manuales

Relacionado con productos y manuales para Los conmutadores de red Dell OPENVIEW NNM SE 1.2