Dell OpenManage Server Administrator Version 5.1 Manual de usuario descargar pdf (Pagina 166)

166 Using the Storage Management Service

omconfig Physical Disk Commands

The following sections provide the omconfig command syntax required to execute physical disk tasks.

omconfig Blink Physical Disk

You can blink the light (light emitting diode or LED display) on one or more physical disks attached to a

controller. Use the following omconfig command syntax to blink one or more physical disks.

Complete Syntax

action=blink controller=ID action=blink controller=id pdisk=<PDISKID>

where id is the controller ID. The <PDISK> variable specifies the physical disk.

To obtain these values, enter omreport storage controller to display the controller IDs and then enter

omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.

Example Syntax

In this example, you want to blink physical disk 0 on connector 0 of controller 1. On a SAS controller, the

physical disk resides in enclosure 2.

Example for SCSI, SATA, and ATA Controllers:

To blink the physical disk described in this example, enter:

omconfig storage pdisk action=blink controller=1 pdisk=0:0

Table 8-23. omconfig Physical Disk Commands

Required Command Levels (1, 2, 3) Optional name=value pairs

omconfig storage pdisk

action=blink controller=id pdisk=<PDISKID>

action=unblink controller=id pdisk=<PDISKID>

action=remove controller=id pdisk=<PDISKID>

action=initialize controller=id pdisk=<PDISKID>

action=offline controller=id pdisk=<PDISKID>

action=online controller=id pdisk=<PDISKID>

action=assignglobalhotspare controller=id pdisk=<PDISKID>

assign=<yes|no>

action=rebuild controller=id pdisk=<PDISKID>

action=cancelrebuild controller=id pdisk=<PDISKID>

action=removedeadsegments controller=id pdisk=<PDISKID>

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 221 222

Sin comentarios

Dell OpenManage Server Administrator Version 5.1 Manual de usuario Pagina 166