Dell Force10 S25-01-GE-24P Guía de instalación descargar pdf (Pagina 18)

18 Installation

Node Manager Installation

Ideally, you would install another copy of Node Manager on a separate PC for each chassis that you want

to manage through Node Manager. However, you can use one installation of Node Manager to manage

multiple switches as long as you close and relaunch Node Manager each time you want to manage a

different switch.

You identify the managed chassis to Node Manager through the management IP address assigned to that

chassis (see C-Series and E-Series Setup on page 25 and S-Series Setup on page 26).

Some screenshots below are for earlier Node Manager versions, but they pertain to the current version.

Note: You only need to install Node Manager separately if you did not previously install Force10

Management System (FTMS). The FTMS installation installs Node Manager automatically.

Step Task

1 Log in as Administrator in Windows and as root in Solaris and Linux. You must have administrative

rights to install Node Manager.

2 Navigate to the drive and directory where you keep the Node Manager software.

For Windows:

In the directory where you keep your copy of the Node Manager software, double-click Install.exe.

For UNIX:

Open a terminal to go to the directory containing the Node Manager installer (install.bin). Assuming

install.bin is in /usr/local, execute the following commands:

$ cd /usr/local

$ chmod 755 install.bin

$ ./install.bin

3 The installation wizard loads the installation application. To exit the procedure, click Cancel.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 123 124

Sin comentarios

Dell Force10 S25-01-GE-24P Guía de instalación Pagina 18