Dell Force10 S25-01-GE-24P Guía de instalación descargar pdf (Pagina 97)

Force10 Node Manager Guide, version 1.5.0 97

Configuring S-Series Interfaces

Node Manager enables you to perform these management activities on interfaces:

• Configuring S-Series Switch Interfaces

• Enabling and Shutting Down S-Series Ports

• Telneting to an S-Series Switch Interface

• Managing S-Series Port Channels on page 99

• Using S-Series Bulk Configuration on page 110

Configuring S-Series Switch Interfaces

To configure a switch interface:

Step Task

Right-click the icon of the port you wish to configure. If you have not yet logged into the CLI, Node

Manager prompts you to do so. Node Manager displays a pop-up menu of available options.

2 Click Config. Node Manager displays this dialog box:

Figure 72 Interface Dialog Box (S-Series Port Configuration)

3 Enter your selections. The following table contains a description of each field:

Field Name Usage

Speed and Duplex Sets the speed and duplex setting for the interface.

MTU Enables you to enter a link Maximum Transmission Unit (MTU) size for the

interface. Range: 1518 to 9216 bytes.

OSPF area ID Assign the interface to an OSPF area. This feature is not available when

only the Layer 2 package of SFTOS is installed on the subject switch.

4 Click Apply or OK to make your change(s), or click Reset to reload the default settings.

5 Choose OK or Close to exit.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 123 124

Sin comentarios

Dell Force10 S25-01-GE-24P Guía de instalación Pagina 97