Dell Force10 S25-01-GE-24P Guía de instalación descargar pdf (Pagina 92)

92 Managing the S-Series

Renumbering a Switch Member in an S50 Stack

You can renumber a stack member unit in Node Manager.

To renumber a switch in Node Manager:

Setting Priority on a Switch Member in an S50 Stack

You can set the priority value of a stack member unit in Node Manager. This value is used in the

management unit election algorithm.

To set the priority value of a member unit in Node Manager:

Note: Renumbering of the management unit is disabled, because renumbering the management

unit would break the connection to the box from the management plane.

Note: The member unit must exist physically, not simply in the Node Manager graphic.

Step Task

1 Right-click the picture of the switch member you wish to renumber. (Do not click a port icon or your

results will be different.) Then, Node Manager displays a pop-up menu of available options.

2 Select renumber. If you have not previously logged into the CLI, Node Manager prompts you to do

so. After you have logged in, Node Manager displays this dialog box:

Figure 67 Switch Renumber Dialog Box (S50 Stack)

3 Set the new switch index value, then click OK. Node Manager renumbers the member on the stack.

Step Task

1 Right-click the graphic of the member unit for which you want to set a new priority value. (Do not click

a port icon or your results will be different.) Node Manager displays a pop-up menu.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 123 124

Sin comentarios

Dell Force10 S25-01-GE-24P Guía de instalación Pagina 92