Dell Force10 S25-01-GE-24P Guía de instalación descargar pdf (Pagina 56)

56 Managing the E-Series

If you replace an existing line card with one from a different series, you must configure the system with the

updated line card information. Refer to the CLI Commands section of the installation document that

accompanies each card for more information about this process.

You can perform these line card management activities with Node Manager:

• Displaying Line Card Information on page 56

• Adding Logical Line Cards on page 59

• Deleting Logical Line Cards on page 60

Displaying Line Card Information

To view line card information:

Warning: Always wear an ESD-preventative wrist or foot-ground heel strap when handling line

cards. After you remove the original packaging, place components on an anti-static surface.

Step Task

1 Right-click inside the picture of the line card you wish to examine. (Do not click a port icon or your

results will be different.) If you have not yet logged into the CLI, Node Manager prompts you to do so.

Node Manager displays a pop-up menu of available options:

• Module Info (see Figure 31 on page 57)

• Interface Info (see Figure 32 on page 58)

• Config Interfaces (This menu item invokes a window that is also invoked from the main menu:

Config  Config Interfaces. See Using Bulk Configuration on page 82.)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 123 124

Sin comentarios

Dell Force10 S25-01-GE-24P Guía de instalación Pagina 56