Dell Force10 S25-01-GE-24P Guía de instalación descargar pdf (Pagina 26)

26 Installation

S-Series Setup

To complete the installation, use SFTOS to configure the management connection on each S-Series

chassis that you want to manage from Node Manager.

Configuring SNMP

Node Manager communicates to each chassis by means of SNMP. This requires that you define an SNMP

community string.

Defining the S-Series Management IP Address

Follow the instructions in the Management chapter of the SFTOS Configuration Guide on configuring the

management IP address of an S-Series chassis for accessing it through an IP connection (such as through

Telnet). Briefly:

For more on S-Series management, see Managing the S-Series on page 85.

Command Syntax Command Mode Usage

snmp-server community name Global Config Enter the community string you wish to use for

Node Manager. Force10 suggests that you

use the same community string for all chassis.

If you have previously entered a string for

another SNMP manager and agent, use the

existing string.

Command Syntax Command Mode Usage

interface managementethernet Global Config Invoke the (Config-if-ma)# prompt.

ip address ipaddr subnetmask (Config-if-ma)# prompt Set the IP address and subnet mask of the

management interface.

management route default gateway Global Config Set the IP gateway of the management

interface.

Note: If you are managing an S50 running SFTOS 2.2 or earlier, use the network parms

command (Global Config mode) to set the management IP address, subnet mask, and default

gateway.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 123 124

Sin comentarios

Dell Force10 S25-01-GE-24P Guía de instalación Pagina 26