Dell PowerConnect W Clearpass 100 Software Guía de usuario Pagina 102

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 296
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 101
102102 | Uplink Configuration
Dell PowerConnect W-Series Aruba Instant 6.2.1.0-3.3 | User Guide
Supported Country list
----------------------
Country list
------------
Supported ISP list
------------------
ISP list
--------
To view the cellular status:
(Instant Access Point)# show cellular status
cellular status
---------------
card detect link
---- ------ ----
Not-present Not-detect Linkdown
Configuring a Wi-Fi Uplink Profile
The following configuration conditions apply to the Wi-Fi uplink:
l To bind or unbind the Wi-Fi uplink on the 5 GHz band, reboot the OAW-IAP.
l If the Wi-Fi uplink is used on the 5 GHz band, mesh is disabled. The two links are mutually exclusive.
l For OAW-IAPs to connect to an AOS-W based WLAN using Wi-Fi uplink, the mobility switch must run AOS-W
6.2.1.0 or later.
To provision an OAW-IAP with the Wi-Fi Uplink, complete the following steps:
1. If you are configuring a Wi-Fi uplink after restoring factory settings on an OAW-IAP, connect the OAW-IAP to an
Ethernet cable to allow the OAW-IAP to get the IP address. Otherwise, go to step 2.
2. Click the System link at the top right corner of the AOS-W Instant main window. The System window is
displayed.
3. Click the Show advanced options link. The advanced options are displayed.
4. Click the Uplink tab.
5. Under Wi-Fi, enter the name of the wireless network that is used for the Wi-Fi uplink in the Name (SSID) text
box.
6. Select the type of key for uplink encryption and authentication from the Key management drop-down list. If the
uplink wireless router uses mixed encryption, WPA-2 is recommended for the Wi-Fi uplink.
7. From the band drop-down list. Select the band in which the Virtual Controller currently operates. The following
options are available:
l 2.4GHz (default)
l 5 GHz
8. Select a passphrase format from the Passphrase format drop-down list. The following options are available:
l 8 - 63 alphanumeric characters
l 64 hexadecimal characters
Ensure that the hexadecimal password string is exactly 64 digits in length.
9. Enter a pre-shared key (PSK) passphrase in the Passphrase text box and click OK.
You can view the W-Fi configuration and uplink status in the CLI. To view the configuration status in the CLI:
(Instant Access Point)# show wifi-uplink status
Vista de pagina 101
1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 295 296

Comentarios a estos manuales

Sin comentarios