Dell PowerConnect W Clearpass 100 Software Guía de usuario descargar pdf (Pagina 110)

110110 | Wired Profiles

Dell PowerConnect W-Series Aruba Instant 6.2.1.0-3.3 | User Guide

b. Primary Usage — Select Employee or Guest.

c. Speed/Duplex — Ensure that appropriate values are selected for Speed/Duplex. Contact your network

administrator if you need to assign speed and duplex parameters.

d. POE — Set POE to Enabled to enable Power over Ethernet.

The E2 port on RAP-3WNP supports Power Sourcing Equipment (PSE) to supply power to any compliant

802.3af powered (class 0-4) device. OAW-RAP155Psupports PSE for 802.3af powered device (class 0-4)

on one port (E1 or E2), or 802.3at powered DC IN (Power Socket) on two ports (E1 and E2).

e. Admin Status — Ensure that an appropriate value is selected. The Admin Status indicates if the port is up or

down.

f. Content Filtering— To ensure that all DNS requests to non-corporate domains on this wired network are sent

to OpenDNS, select Enabled for Content Filtering.

g. Uplink — Select Enabled to configure uplink on this wired profile. If Uplink is set to Enabled and this network

profile is assigned to a specific port, the port will be enabled as Uplink port. For more information on assigning

a wired network profile to a port, see Assigning a Profile to Ethernet Ports on page 116.

4. Click Next. The VLAN tab details are displayed.

5. Configure VLAN for the wired profile. For more information, see Configuring VLAN for a Wired Profile on page

110.

In the CLI

To configure wired settings for:

(Instant Access Point)(config)# wired-port-profile <profile-name>

(Instant Access Point)(wired ap profile<name>)# type {<employee> |<guest>}

(Instant Access Point)(wired ap profile<name>)# speed {10 |100 |1000 |auto}

(Instant Access Point)(wired ap profile<name>)# duplex {<half>|<full>|<auto>}

(Instant Access Point)(wired ap profile<name>)# no shutdown

(Instant Access Point)(wired ap profile<name>)# poe

(Instant Access Point)(wired ap profile<name>)# uplink-enable

(Instant Access Point)(wired ap profile<name>)# content-filtering

(Instant Access Point)(wired ap profile<name>)# end

(Instant Access Point)(wired ap profile<name>)# commit apply

Configuring VLAN for a Wired Profile

If you are creating a new wired profile, complete the WiredSettings procedure before configuring VLAN.

For more information, see Configuring Wired Settings on page 109.

You can configure VLAN using Instant UI or CLI.

In the Instant UI

To configure VLAN:

1. In the VLAN tab, enter the following information.

a. Mode — You can specify any of the following modes:

l Access — Select this mode to allow the port to carry a single VLAN specified as the native VLAN.

l Trunk — Select this mode to allow the port to carry packets for multiple VLANs specified as allowed

VLANs.

b. Specify any of the following values for Client IP Assignment:

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 295 296

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W Clearpass 100 Software Guía de usuario Pagina 110

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W Clearpass 100 Software