Dell PowerConnect W Clearpass 100 Software Guía de usuario descargar pdf (Pagina 149)

3. Under Dynamic Blacklisting:

4. For Auth failure blacklist time, duration in seconds after which the clients that exceed the authentication failure

threshold must be blacklisted.

5. For PEF rule blacklisted time, enter the duration in seconds after which the clients can be blacklisted due to an

ACL rule trigger.

You can configure a maximum number of authentication failures by the clients, after which a client must

be blacklisted. For more information on configuring maximum authentication failure attempts, see

Configuring Security Settings for a WLAN SSID Profile on page 84

To enable session firewall based blacklisting, click New and navigate to WLAN Settings > VLAN >

Security > Access window, and enable the Blacklist option of the corresponding ACL rule.

In the CLI

To dynamically blacklist clients:

(Instant Access Point)(config)# auth-failure-blacklist-time <seconds>

(Instant Access Point)(config)# blacklist-time <seconds>

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

To view the blacklisted clients:

(Instant Access Point)# show blacklist-client config

Blacklist Time :60

Auth Failure Blacklist Time :60

Manually Blacklisted Clients

----------------------------

MAC Time

--- ----

Dynamically Blacklisted Clients

-------------------------------

MAC Reason Timestamp Remaining time(sec) AP IP

--- ------ --------- ------------------- -----

Dyn Blacklist Count :0

Blacklisting Clients Manually

Manual blacklisting adds the MAC address of a client to the blacklist. These clients are added into a permanent

blacklist. These clients are not allowed to connect to the network unless they are removed from the blacklist.

Adding a Client to the Blacklist

You can add a client to the blacklist manually using Instant UI or CLI.

In the Instant UI

1. Click the Security link from the top right corner of the Instant main window.

2. Click the Blacklisting tab.

3. Under the Manual Blacklisting, click New .

4. Enter the MAC address of the client to be blacklisted in the MAC address to add text box.

5. Click OK. The Blacklisted Since tab displays the time at which the current blacklisting has started for the client.

6. To delete a client from the manual blacklist, select the MAC Address of the client under the Manual Blacklisting,

and then click Delete.

In the CLI

To blacklist a client:

AOS-W Instant 6.2.1.0-3.3| User Guide Authentication | 149

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 295 296

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W Clearpass 100 Software Guía de usuario Pagina 149

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W Clearpass 100 Software