Dell PowerConnect W Clearpass 100 Software Guía de usuario descargar pdf (Pagina 165)

arp packet counter 0

drop bad arp packet counter 0

dhcp response packet counter 0

fixed bad dhcp packet counter 0

send arp attack alert counter 0

send dhcp attack alert counter 0

arp poison check counter 0

garp send check counter 0

Configuring User Roles

Every client in the AOS-W Instant network is associated with a user role, which determines the client’s network

privileges, the frequency of reauthentication, and the applicable bandwidth contracts.

Instant supports role derivation based on DHCP option for Captive Portal authentication. When the Captive Portal

authentication is successful, a new user role is assigned to guest users based on DHCP option configured for the

SSID profile, instead of the pre-authenticated role.

Instant now supports role derivation based on DHCP option for Captive Portal authentication. When the

Captive Portal authentication is successful, a new user role is assigned to the guest users based on

DHCP option configured for the SSID profile, instead of the pre-authenticated role.

This section describes the following procedures:

l Creating a User Role on page 165

l Configuring User Roles on page 165

l Configuring Machine and User Authentication Roles on page 166

Creating a User Role

You can create a user role by using Instant UI or CLI.

In the Instant UI

To create a user role:

1. Click the Security at the top right corner of Instant main window.

2. Click Roles tab. The Roles tab contents are displayed.

3. Under Roles, click New.

4. Enter a name for the new role and click OK.

You can also create a user role when configuring wireless or wired network profiles. For more information,

see Configuring Access Rules for a WLAN SSID Profile on page 91 and Configuring Access Rules for a

Wired Profile on page 113

In the CLI

To configure user roles and access rules:

(Instant Access Point)(config)# wlan access-rule <access-rule-name>

(Instant Access Point)(Access Rule <Name>)# rule <dest> <mask> <match> <protocol> <start-port>

<end-port> {permit |deny | src-nat | dst-nat {<IP-address> <port> | <port>}}

[<option1....option9>]

AOS-W Instant 6.2.1.0-3.3| User Guide Roles and Policies | 165

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 295 296

Sin comentarios

Dell PowerConnect W Clearpass 100 Software Guía de usuario Pagina 165