Dell PowerConnect W Clearpass 100 Software Guía de usuario descargar pdf (Pagina 69)

5. Select the Adaptive radio management assigned option under the bands that are applicable to the OAW-IAP

configuration.

6. Click OK.

Configuring Radio Profiles Manually for an OAW-IAP

To manually configure radio settings:

1. In the Access Points tab, click the AP for which you want to enable ARM. The edit link appears.

2. Click the edit link. The Edit Access Point window appears.

3. Click the Radio tab.

4. Ensure that an appropriate mode is selected.

In the Monitor and Spectrum Monitor modes, the APs do not provide access services to clients.

By default the channel and power for an AP are optimized dynamically using Adaptive Radio Management

(ARM). You can override ARM on the 2.4 GHz and 5 GHz bands and set the channel and power manually if

desired. The following table describes various modes of for an AP.

5. Select Administrator assigned in 2.4 GHz and 5 GHz band sections.

6. Select appropriate channel number from the Channel drop-down list for both 2.4 GHz and 5 GHz band sections.

7. Enter appropriate transmit power value in the Transmit power text box in 2.4 GHz and 5 GHz band sections.

8. Click OK.

In the CLI

To configure a radio profile:

(Instant Access Point)# wifi0-mode {<access>|<monitor>|<spectrum-monitor>}

(Instant Access Point)# wifi1-mode {<access>|<monitor>|<spectrum-monitor>}

(Instant Access Point)# a-channel <channel> <tx-power>

(Instant Access Point)# g-channel <channel> <tx-power>

Configuring Inter-user Bridging and Local Routing

You can configure inter-user bridging and local routing by using the Instant UI or CLI.

In the Instant UI

To prevent inter-user bridging and local routing:

1. In the Instant main window, click the System link. The System window appears.

2. In the General tab of System window, click Show advanced options to display the advanced options.

l From the Deny inter user bridging drop-down menu, select Enabled to prevent traffic between two clients

connected to the same OAW-IAP.

l From the Deny local routing drop-down menu, select Enabled to prevent local routing traffic between two

clients connected to the same OAW-IAP.

In the CLI

To configure inter-user bridging and local routing:

(Instant Access Point)(config)# deny-inter-user-bridging

(Instant Access Point)(config)# deny-local-routing

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

AOS-W Instant 6.2.1.0-3.3| User Guide Basic Configuration Procedures | 69

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 295 296

Sin comentarios

Dell PowerConnect W Clearpass 100 Software Guía de usuario Pagina 69