Dell PowerConnect W-Airwave 8.0 Manual de usuario descargar pdf (Pagina 164)

Setting Default Device Type Description

Subnet Mask None All

Provides the IP subnet mask to identify the sub-network so

the IP address can be recognized on the LAN. If DHCP is

enabled, the current assigned address will appear grayed

out and the field cannot be updated in this area.

Gateway None All

The IP address of the default internet gateway. If DHCP is

enabled, the current assigned address will appear grayed

out and the field cannot be updated in this area.

Table 85:

Additional Settings (Continued)

5. Locate the Template Options area on the APs/Devices > Manage page.

This section only appears for IOS APs, Symbol devices, and Dell Networking W-Series controllers in groups with Dell

Networking W GUI Config disabled.

Table 86 describes field settings, default values, and additional information for this page.

Setting Default

Device

Type

Description

WDS Role Client

Cisco IOS

Wireless

LAN

Controllers

only

Set the WDS role for this AP. Select Master for the WDS master

APs and Client for the WDS Client. Once this is done you can

use the %if wds_role= % to push the client, master, or backup

lines to appropriate WDS APs.

SSL Certificate None Cisco IOS

AirWave will read the SSL Certificate off of the AP when it

comes UP in AirWave. The information in this field will defines

what will be used in place of %certificate%.

Extra Device

Commands

None Cisco IOS

Defines the lines that will replace the %ap_include_1%

variable in the IOS template. This field allows for unique

commands to be run on individual APs. If you have any settings

that are unique per AP like a MOTD you can set them here.

switch_command None

Cisco

Catalyst

switches

Defines lines included for each of the members in the stack.

This field appears only on the master's Manage page. The

information in this field will determine what is used in place of

the %switch_command% variable.

Table 86:

APs/Devices > Manage > Template Options Fields and Default Values

6. For Cisco WLC devices, go to the interfaces section of the APs/Devices > Manage page. Select Add new Interface

to add another controller interface, or select the pencil icon to edit an existing controller interface. Table 87 describes

the settings and default values. For detailed descriptions of Cisco WLC devices supported by AirWave, refer to the

Cisco WLC product documentation.

Field Default Description

Name None The name of the interface on the controller.

VLAN ID None The VLAN ID for the interface on the controller.

Table 87:

APs/Devices > Manage > Interface Fields and Descriptions for Cisco WLC Devices

Dell Networking W-AirWave 8.0 | User Guide Discovering, Adding, and Managing Devices | 164

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 376 377

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 164

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 8.0