Dell PowerConnect W-Airwave 8.0 Manual de usuario descargar pdf (Pagina 343)

343 | Using VisualRF Dell Networking W-AirWave 8.0 | User Guide

By default the importation wizard allocates 2,500 grid cells to each site based on dimensions. If you have a site that is

250 ft. by 100 ft, the Floor Plan importation wizard would calculate the grid cell size at 10 feet. 250 ft. x 100 ft. =

25,000 ft. 25,000 ft. / 2,500 ft. = 10 ft.

Decreasing the grid cell size will increase accuracy, but it also increase CPU consumption by the floor caching threads and

the location caching threads. Check the System > Performance page to ensure your server is functioning properly when

you make a change to this setting.

Other items worth noting:

l If this is a CAD file, then the Floor Plan creation wizard will automatically inherit height and width from the

drawing.

l If this is a non-CAD file, then the height and width is zero.

l CAD files are converted to a JPG with a resolution of 4096 horizontal pixels at 100% quality prior to cropping. If

you crop, then you will lose clarity.

l CAD files must be generated from AutoCAD and may not exceed 10 MB.

l Metric CAD files are supported.

l Importing GIF files for floor plans can result in blank VisualRF thumbnails.

Sizing a Non-CAD Floor Plan

You should not have to resize a CAD drawing unless you see nonsensical dimensions. To resize a non-CAD image if

you already know the dimensions, follow the procedures below.

To resize a Non-CAD floor plan using the HTML5 UI:

1. In the Scale section of the floor upload wizard, click the Measure button. The pointer changes to a cross-hair icon.

2. Locate two points within the floor plan that you know the distance. Most door jams (door openings) are 3 feet. Use

the slider bar at the upper left corner of the upload wizard to zoom in to a section of the floor plan, if necessary.

3. Select and hold to establish the first point and drag your mouse to the second point and release.

4. An Enter Distance dialogue box appears. Enter the proper length in feet, as shown in Figure 218.

5. Click OK.

Figure 218:Manually Measuring a Floor Plan

To Resize a Non-CAD Floor Plan using the Legacy Flash UI

1. In the Dimensions section, select the Manually Measure Floor button. The pointer changes to a cross-hair icon.

2. Locate two points within the floor plan that you know the distance. Most door jams (door openings) are 3 feet.

3. Click on the flooplan to establish the first point.

4. Click on the floorplan to establish the second point.

5. A distance dialogue box appears. Enter the proper length in feet.

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 376 377

Sin comentarios

Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 343