Dell PowerConnect W-Airwave 8.0 Manual de usuario descargar pdf (Pagina 54)

54 | Configuring AirWave Dell Networking W-AirWave 8.0 | User Guide

Figure 25:AMP Setup > Authentication Page Illustration for TACACS+

2. Select No to disable or Yes to enable TACACS+ authentication. If you select Yes, several new fields appear.

Complete the fields described in Table 25.

Field Default Description

Primary Server Hostname/IP

Address

N/A

Enter the IP address or the hostname of the primary TACACS+

server.

Primary Server Port (1-65535) 49 Enter the port for the primary TACACS+ server.

Primary Server Secret N/A

Specify and confirm the primary shared secret for the primary

TACACS+ server.

Confirm Primary Server Secret N/A Re-enter the primary server secret.

Secondary Server

Hostname/IP Address

N/A

Enter the IP address or hostname of the secondary TACACS+

server.

Secondary Server Port (1-

65535)

49 Enter the port for the secondary TACACS+ server.

Secondary Server Secret N/A Enter the shared secret for the secondary TACACS+ server.

Confirm Secondary Server

Secret

N/A Re-enter the secondary server secret.

Table 25:

AMP Setup > Authentication Fields and Default Values for TACACS+ Authentication

3. Select Save and continue with additional steps.

Configuring Cisco ACS to Work with AirWave

To configure Cisco ACS to work with AirWave, you must define a new service named AMP that uses https on the ACS

server.

1. The AMP https service is added to the TACACS+ (Cisco) interface under the Interface Configuration tab.

2. Select a checkbox for a new service.

3. Enter AMP in the service column and https in the protocol column.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 376 377

Sin comentarios

Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 54