Dell PowerConnect W-Airwave 8.0 Manual de usuario descargar pdf (Pagina 87)

87 | Configuring and Using Device Groups Dell Networking W-AirWave 8.0 | User Guide

Setting Default Description

Interface Error Counter

Polling Period

minutes

Sets the frequency in which network interfaces are polled for up/down

status. This setting can be disabled, or set to poll bridge forwarding

tables from switches in a range from every 5 minutes to 30 minutes.

Poll 802.3 error counters No Sets whether 802.3 error counters should be polled.

Poll Cisco interface error

counters

Sets whether the interface error counters for Cisco devices should be

polled.

Table 43:

Routers and Switches Fields and Default Values (Continued)

4. Record additional information and comments about the group in the Notes section.

5. To configure which options and tabs are visible for the group, complete the settings in the Group Display Options

section. Table 44 describes the settings and default values.

Setting Default Description

Show device

settings for

Only

devices

on this

AMP

Drop-down menu determines which Group tabs and options are to be viewable by

default in new groups. Settings include the following:

l All Devices—AirWave displays all Group tabs and setting options.

l Only devices in this group—AirWave hides all options and tabs that do not

apply to the devices in the group. If you use this setting, then to get the group

list to display the correct SSIDs for the group, you must Save and Apply on the

group.

l Only devices on this AMP— hides all options and tabs that do not apply to the

APs and devices currently on AirWave.

l Use system defaults—Use the default settings on AMP Setup > General

l Selected device types—Allows you to specify the device types for which

AirWave displays Group settings.

Selected

Device Types

N/A

This option appears if you chose to display selected device types, allowing you to

select the device types to display group settings. Use Select devices in this group

to display only devices in the group being configured.

Table 44:

Group Display Options Fields and Default Values

6. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the

Automatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this section,

additional fields appear. Complete these fields as required. Table 45 describes the settings and default values This

section is only relevant for a small number of device types, and will appear when they are present.

Setting Default Description

Assign Static

IP Addresses

to Devices

Specify whether to enable AirWave to statically assign IP addresses from a

specified range to all devices in the Group. If this value is set to Yes, then the

additional configuration fields described in this table will become available.

Start IP

Address

none Sets the first address AirWave assigns to the devices in the Group.

Number of

Addresses

none

Sets the number of addresses in the pool from which AirWave can assign IP

addresses.

Table 45:

Automatic Static IP Assignment Fields and Default Values

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 376 377

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 87

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 8.0