Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 190

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 377
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 189
service avt
%avt_ingress_interface%
%avt_ingress_ip%
buffer_time 200
mode %avt_mode%
AirWave displays a warning if AirMesh APs attempting to either upgrade or push configurations lack the necessary write
permissions.
Configuring Cisco IOS Templates
Cisco IOS access points have hundreds of configurable settings. AirWave enables you to control them via the Groups >
Templates configuration page. This page defines the startup-config file of the devices rather than using the AirWave
normal Group configuration pages. AirWave no longer supports making changes for these devices via the browser-based
page, but rather uses templates to configure all settings, including settings that were controlled formerly on the AirWave
Group configuration pages. Perform these steps to configure a Cisco IOS Template for use with one or more groups, and
the associated devices.
This section includes the following topics:
l "Applying Startup-config Files" on page 190
l "WDS Settings in Templates" on page 190
l "SCP Required Settings in Templates" on page 191
l "Supporting Multiple Radio Types via a Single IOS Template" on page 191
l "Configuring Single and Dual-Radio APs via a Single IOS Template" on page 191
Applying Startup-config Files
Each of the APs in the Group copies its unique startup-config file from AirWave via TFTP or SCP.
l If the Reboot Devices after Configuration Changes option is selected, then AirWave instructs the AP to copy the
configuration from AirWave to the startup-config file of the AP and reboot the AP.
l If the Reboot Devices after Configuration Changes option is not selected, then AirWave instructs the AP to copy
the configuration to the startup-config file and then tell the AP to copy the startup config file to the running-config
file. Use the reboot option when possible. Copying the configuration from startup to running merges the two
configurations and can cause undesired configuration lines to remain active on the AP.
Changes made on the standard AirWave Group configuration pages, to include Basic, Radio, Security, VLANs, and so
forth, are not applied to any template-based APs.
WDS Settings in Templates
A group template supports Cisco WDS settings. APs functioning in a WDS environment communicate with the Cisco
WLSE via a WDS master. IOS APs can function in Master or Slave mode. Slave APs report their rogue findings to the
WDS Master (AP or WLSM which reports the data back to the WLSE. On the APs/Devices > Manage configuration
page, select the proper role for the AP in the WDS Role drop down menu.
The following example sets an AP as a WDS Slave with the following lines:
%if wds_role=client%
wlccp ap username wlse password 7 XXXXXXXXXX
%endif%
The following example sets an AP as a WDS Master with the following lines:
%if wds_role=master%
aaa authentication login method_wds group wds
Dell Networking W-AirWave 8.0 | User Guide Creating and Using Templates | 190
Vista de pagina 189
1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 376 377

Comentarios a estos manuales

Sin comentarios