Dell PowerConnect W-Airwave 8.0 Manual de usuario descargar pdf (Pagina 38)

38 | Configuring AirWave Dell Networking W-AirWave 8.0 | User Guide

Setting Default Description

Prefer AMONvs

SNMP Polling

SNMP

Polling

Prefer AMON is a configuration setting which causes AirWave to use an

AMON feed to obtain client monitioring information from a controller rather

than polling it via SNMP. When you enable this setting, values such as AP

lists and rogue AP lists are still polled via SNMP, but the bulk of client client

monitoring information is delivered via AMON.

Before enabling the Prefer AMON setting, please note the following:

l When Prefer AMON is enabled, the controller must be configured to

send AMON to AirWave.

l The network path from the controller to the AirWave server must allow

traffic on UDP port 8211.

l The controller routinely sends AMON in large UDP packets, (up to 30K

bytes). Before enabling this setting, ensure the network path from the

controller to AirWave can pass such large packets intact.

l This setting should only be used in a network environment with low

levels of UDPpacket loss, as the loss of a single Ethernet frame will

potentially result in the loss of up to 30K bytes worth of data.

Enable Syslog and

SNMP Trap

Collection

Yes

This option specifies whether traps used to detect roaming events, auth

failures, AP up/down status, and IDS events will still be collected if they are

sent by managed devices.

Table 12:

AMP Setup > General > Additional AMP Services Fields and Default Values (Continued)

Performance Settings

Locate the Performance section. Performance tuning is unlikely to be necessary for many AirWave implementations,

and likely provides the most improvements for customers with extremely large Pro or Enterprise installations. Please

contact Dell support at dell.com/support if you think you might need to change any of these settings. Table 13 describes

the settings and default values of this section.

Setting Default Description

Monitoring

Processes

Based on the

number of

cores for

your server

Optional setting configures the throughput of monitoring data.

Increasing this setting allows AirWave to process more data per

second, but it can take resources away from other AirWave

processes. Contact Dell support at dell.com/support if you think you

might need to increase this setting for your network. Also note that the

value range varies based on the number of available process cores.

Maximum number

of configuration

processes

Increases the number of processes that are pushing configurations to

your devices, as an option. The optimal setting for your network

depends on the resources available, especially RAM. Contact Dell

support at dell.com/support if you think you might need to increase

this setting for your network.

Maximum number

of audit processes

Increases the number of processes that audit configurations for your

devices, as an option. The optimal setting for your network depends

on the resources available, especially RAM. Contact Dell support at

dell.com/supportif you are considering increasing this setting for your

network.

SNMP Fetcher

Count (2-6)

2 Specify the number of SNMPv2 fetchers.

Table 13:

AMP Setup> General > Performance Fields and Default Values

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 376 377

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 8.0 Manual de usuario Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 8.0