Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 102)

102 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide

4. Certain wireless access points offer proprietary settings or advanced functionality that differ from prevailing

industry standards. If you use these APs in the device group, you may wish to take advantage of this

proprietary functionality.

To configure these settings, locate the

proprietary settings areas on the Groups > Radio page and continue

with the additional steps in this procedure.

5. To configure HP ProCurve 420 set

tings exclusively, locate the HP ProCurve 420 section and adjust these

settings as required. Table 62 describes the settings and default values.

6. To configure the HP ProCurve 240, Enterasys

AP 3000 and AP 4102 Operational Mode and Max Station Data

Rate, locate the HP ProCurve 240, Enterasys AP 3000 and AP 4102 section of the Proprietary Settings area,

and define the settings. Table 63 describes the settings and default

values of this page.

7. To configure settings specific to Enterasys AP3000

and Enterasys AP4102, locate the Enterasys AP3000 and

Enterasys AP4102 section of the Proprietary Settings area, and define the settings. Table 64 describes the

settings and default values of this page.

Note: Proprietary settings are only applied to devices in the group from the specific vendor and are not configured on devices

from vendors that do not support the functionality.

Table 62 HP ProCurve 420 Fields and Default Values

Setting Default Description

Slot Time Auto Short-slot-time mechanism, if used on a pure 802.11g deployment, improves

WLAN throughput by reducing wait time for transmitter to assure clear channel

assessment.

Multicast Data Rate 5.5Mbps Sets the maximum data rate of the multicast data packets.

Rogue Scanning Enabled If enabled the 420 APs in the group will scan for rogues.

Rogue Scanning Interval (15-

100

80 min)

720 If rogue scanning is enabled, this setting controls the frequency with which

scans are conducted (in minutes). Frequent scans provide the greatest security,

but AP performance and throughput available to user devices may be impacted

modestly during a rogue scan.

NOTE: This se

tting only applies to Periodic scans.

Rogue Scanning Duration (50-

100

0 msec)

350 Specifies the amount of time, in milliseconds, the AP should spend performing

the rogue scan. If the duration is set too high users may start to experience

connectivity issues.

NOTE: This se

tting only applies to periodic scans.

Rogue Scan Type Periodic Specifies the Rogue Scanning mode. When set to Dedicated, user

s are unable to

associate to the AP.

Table 63 HP ProCurve 240, Enterasys AP 3000 and AP 4102 Fields and Default Values

Setting Default Description

Operational Mode 802.11b +

802.11g

Sets the radio operational mode for all of the ProCurve 420s, Enterasys 3000s and

4102sin the group to either b only, g only,

or b + g.

Max Station Data Rate 54 Mbps The maximum data rate at which a user can connect to the AP.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 333 334

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 102

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 7.1