Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 90)

90 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide

16. To configure settings for 3Com, Enterasys, Nortel, or Trapeze devices, locate the 3Com/Enterasys/Nortel/

Trapeze section and adjust these settings as required. Table 50 describes the settings and default values of this

section.

17. To configure support for routers and switche

s in the Access Points group, locate the Routers and Switches

section and adjust these settings as required. This section defines the frequency in which all devices in the

Access Points group poll for IP routing information. This can be disabled entirely as desired. Table 51

describes the settings and default

values of this section.

18. To configure settings for universal d

evices on the network, including routers and switches that support both

wired and wireless networks, locate the Universal Devices, Routers and Switches section of the Groups >

Basic page and define the version of SNMP to be supported.

19. Click Save when the configurations of

the Groups > Basic configuration page are complete to retain these

settings, but without pushing these settings to all devices in the Access Points group. Save is a good option if

you intend to make additional device changes in the Access Points group, and wish to wait until all

configurations are complete before you push all configurations at one time.

Click Save and

Apply to save and push these configurations to devices immediately in the Access Points

group, or click Revert to return to the most recently saved settings.

What Next?

Continue to additional sections in this chapter to create new groups or to edit existing groups.

Once general group-level configurations are

complete, continue to later chapters in this document to add or edit

additional device-level configurations and to use several additional AWMS functions.

Table 50 3

Com/Enterasys/Nortel/Trapeze Fields and Default Values

Setting Default Description

SNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to the AP.

Table 51 Routers and Switches Fields and Default Values

Setting Default Description

Read ARP Table 4 hours Sets the frequency in which devices poll routers and switches for Address Resolution

Protocol (ARP) table information. This setting can be disabled, or set to poll for ARP

information in a range from every 15 seconds to 12 hours.

Read CDP Table for

Device Discovery

4 hours Sets the frequency in which devices poll routers and switches for

Cisco Discovery Protocol

(CDP) information. This setting can be disabled, or set to poll for CDP neighbor information in

a range from every 15 seconds to 12 hours.

Read Bridge

Forwarding T

able

4 hours Sets the frequency in which devices poll the network for bridge forwarding information. This

setting can be disabled, or set to poll bridge forwarding tables from switches in a range from

every 15 seconds to 12 hours.

Interface Polling

Peri

5 minutes Sets the frequency in which network interfaces are polled. This setting can be disabled, or set

to poll bridge forwarding tables from switches in a range from every 15 seconds to 12 hours.

Table 52 Universal Devices, Routers and Switches Fields and Default Values

Setting Default Description

SNMP Version 2c Drop-down menu specifies the version of SNMP used by AWMS to communicate with

universal devices on the network.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 333 334

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 90

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 7.1