Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 86)

86 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide

5. Record additional information and comments about the group in the Notes section.

6. To configure which options and tabs

are visible for the group, complete the settings in the Group Display

Options section. Table 40 describes the settings and default values.

7. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the

tomatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this

section, additional fields appear. Complete these fields as required. Table 41 describes the settings and

default values.

CDP Neighbor Data Polling

Period

30 minutes Sets the frequency in which this group polls the network for Cisco Discovery

Protocol (CDP) neighbors.

Table 40 Group Display Options Fields and Default Values

Setting Default Description

Show device

settings for:

Only Devices on

this AMP

Drop-down menu determines which Group tabs and options are to be viewable by

default in new groups.

Settings include the following:

 All Devices—AWMS displays all Group tabs and setting options.

 Only Devices in this group—AWMS hides all options and tabs that do not apply to

the devices in the group. If you use this setting, then to get the group list to display

the correct SSIDs for the group, you must perform a Save and Apply action on the

group.

 Only Devices on this AMP—AWMS hides all options and tabs that do not apply to

the APs and devices currently on AWMS.

 Use system defaults—Use the default settings defined on the AWMS configuration

page

 Selected device types—Allows the user to specify the device types for which

AWMS displays Group settings.

Selected Device

Types

Disabled If you chose to display selected device types, then this option appears, allowing you to

select the device types for which AWMS displays group settings. Click Select devices in

this group for a quick way to display only devices in the current group being configured.

Table 41 Automatic Static IP Assignment Fields and Default Values

Setting Default Description

Assign Static IP

Addresses to

Devices

No Enables AWMS to statically assign IP addresses from a specified range to all devices in

the Group.

Start IP Address Blank Sets the first address AWMS assigns to the

devices in the Group.

Number of

Addresses

Blank Sets the number of addresses in the pool fro

m which AWMS can assign IP addresses.

Subnet Mask Blank Sets the subnet mask to be assigned to the devices in the Group.

Subnet Gateway Blank Sets the gateway to be assigned to the devices in the Group.

Next IP Address Blank Defines the next IP address queued for assignment. Th

is field is disabled for the initial

Access Points group.

Table 39 SNMP Polling Period Fields and Default Values (Continued)

Setting Default Description

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 333 334

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 86

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 7.1