Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 217)

Dell PowerConnect W AirWave 7.1 | User Guide Performing Daily Administration in AWMS | 217

Table 112 Device Trigger Types

Device Trigger Options Description

Device Down This is the default type whenever configuring a new trigger. This type of trigger activates

when an authorized, managed AP has failed to respond to SNMP queries from AWMS.

To set the conditions for this trigger type, click Add in the Conditions section. Complete the

conditions with the Option, Condition, and Value drop-down menus. The conditions establish

the device type. Multiple conditions can apply to this type of trigger. The Device Down trigger

can be configured to send alerts for thin APs when the controller is down; this behavior is

turned off by default.

Device Up This trigger type activates when

an authorized, previously down AP is now responding to

SNMP queries.

To set the conditions for this trigger type, click Add in the

Conditions section. Complete the

conditions with the Option, Condition, and Value drop-down menus. The conditions establish

the type that a device is or is not. Multiple conditions can apply to this type of trigger.

Configuration Mismatch This trigger type activates when

the actual configuration on the AP does not match the

defined Group configuration policy.

To set the conditions for this trigger type, click Add in the Conditions section. Complete the

conditions with the Option, Condition, and Value drop-down menus. The conditions establish

the type that a device is or is not. The conditions establish the type that a device is or is not.

Multiple conditions can apply to this type of trigger.

AP User Count This trigger type activates when

the user count on a given AP device reaches a specific

threshold. The number of user devices associated to an AP has exceeded a predefined

threshold for more than a specified period, in seconds (such as more than 10 users

associated for more than 60 seconds). Selecting AP User Count displays an additional

Duration setting. Define the Duration, which can be expressed as hours, minutes, seconds, or

a combination of these. Click the Add New Trigger Condition button to create one or more

conditions for the User Count trigger.

Figure 143 Sample of Trigger Condition for AP Device User Count

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 333 334

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 217