Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 45)

Dell PowerConnect W AirWave 7.1 | User Guide Configuring AWMS | 45

8. On the AMP Setup > General page, locate the Additional AMP Services section, and adjust settings as

required. Table 14 describes the settings and default values of this section.

9. On the AMP Set

up > General page, locate the Performance Tuning section. Performance tuning is unlikely

to be necessary for many AWMS implementations, and likely provides the most improvements for customers

with extremely large Pro or Enterprise installations. Please contact Dell support if you think you might need to

change any of these settings. Table 15 describes the settings and default values of this section.

Simultaneous Devices

per Job

(1-1000)

20 Defines the number of devices that can be in the process of upgrading at the same time.

AWMS only runs one TFTP transfer at a time. As soon as the transfer to a device has

completed, the next transfer begins, even if the first device is still in the process of

rebooting or verifying configuration.

Failures Before

Stopping (0-20)

1 Sets the default number of upgrade failures before AW

MS pauses the upgrade process.

User intervention is required to resume the upgrade process. Setting this value to 0

disables this function.

Table 14 AMP Setup > General > Additional AMP Services Fields and Default Values

Setting Default Description

Enable FTP Server No Enables or disables the FTP server on AMP. The FTP server is only used to manage Cisco

Aironet 4800 APs. Aruba recommends disabling the FTP server if you do not have any

Cisco Aironet 4800 APs in the network.

Enable RTLS Collector No Enables or disables the RTLS Collecto

r, which is used to allow AOS controllers to send

RTLS packets to VisualRF. The RTLS server IP address must be configured on each

controller. This function is used for VisualRF to improve location accuracy and to locate

chirping asset tags. This function is supported only for Dell PowerConnect W and Aruba

devices.

With selection of Ye

s, the following additional fields appear:

 RTLS Port—Specify the port for the RTLS server.

 RTLS Username—Enter the user name supported by the RTLS server.

 RTLS Password—Enter the RTLS server password.

Use Embedded Mail

Server

Yes Enables or disables the embedded mail

server that is included with AWMS.

This field supports a Send T

est Email button for testing server functionality. Clicking this

button prompts you with a To and From field in which you must enter valid email

addresses, and a button to send a test email.

Process User Roaming

raps from Cisco WLC

Yes AMP now parses client association and authentication traps from Cisco WLC controllers

to give real time information on users connected to the wireless network.

Enable AMON data

ollection

Yes Allows AMP to collect enhanced data from Aruba devices on certain firmware versions;

see the Aruba Best Practices Guide for more details.

Table 15 AMP Setup > General > Performance Tuning Fields and Default Values

Setting Default Description

Monitoring

Processes

Based on the number

of cores for your

server

Optional setting configures the throughput of monitoring data. Increasing this

setting allows AWMS to process more data per second, but it can take

resources away from other AWMS processes. Please contact Dell support if

you think you might need to increase this setting for your network.

Table 13 AMP Setup > General > Default Firmware Upgrade Options Fields and Default Values

Setting Default Description

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 333 334

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 7.1