Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 96)

96 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide

5. Locate the Encryption area on the Groups > SSIDs page and adjust these settings as required. Table 56

describes the settings and default values.

6. Locate the EAP

Options area on the Groups > SSIDS page, and complete the settings.

Table 57 describes the settings and default values.

Name None Sets a user-definable name associated with SSID/VLAN combination.

VLAN ID None Indicates the number of the

VLAN designated as the Native VLAN, typically for

management purposes

Service Priority

(Cisco VxWorks only)

None Identifies the delivery priority which packets receive on the VLAN/SSID

(VxWorks only).

Maximum Allowed

Asso

ciations (0-2007)

255 Indicates the maximum number of mobile users which can associate with the

specified VLAN/SSID.

NOTE: 0 means unlimited for Cisco and none for Colubris.

Broadcast SSID (Proxim

ly)

No For specific devices as cited, this setting enables the AP to broadcast the

SSID for the specified VLAN/SSID. This setting works in conjunction with the

Create Closed Network setting on the Groups> Security configuration page.

Proxim devices support a maximum of four SSIDs.

NOTE: This option should be enabled to ensure suppor

t of legacy users.

Partial Closed System

(Proxim only)

No For Proxim only, this setting enables to AP to

send its SSID in every beacon,

but it does not respond to any probe requests.

Unique Beacon

(Proxim only)

No For Proxim only, if more than one SSID is enabled, this option enables them to

be sent in separate beacons.

Block All Inter-client

Communication

Yes For Colubris only, this setting blocks communication between client devices

based on SSID.

Table 56 Groups > SSIDs > Encryption Section Fields and Default Values

Setting Default Description

Encryption Mode No Encryption Drop-down menu determines the level of encryption required for devices to associate

to the APs. The drop-down menu options are as follows. Each option displays

additional encryption settings that must be defined. Complete the associated settings

for any encryption type chosen:

 Optional WEP—Wired Equivalent Privacy, not PCI compliant as of 2010

 Require WEP—Wired Equivalent Privacy, not PCI compliant as of 2010

 Require 802.1x—This encryption type is based on the WEP algorithm.

 Require Leap—Lightweight Extensible Authentication Protocol

 802.1x+WEP—Combines the two encryption types shown

 LEAP+WEP—Combines the two encryption types shown

 Static CKIP—Cisco Key Integrity Protocol

 WPA—Wi-Fi Protected Access protocol

 WPA/PSK—Combines WPA with Pre-Shared Key encryption

 WPA2—Wi-Fi Protected Access 2 encryption

 WPA2/PSK—Combines the two encryption methods shown

Table 55 Groups > SSIDs > SSID/VLAN Section Fields and Default Values (Continued)

Setting Default Description

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 333 334

Comentarios a estos manuales

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 96

Comentarios a estos manuales

Relacionado con productos y manuales para Software Dell PowerConnect W-Airwave 7.1