Dell PowerConnect W-Airwave 7.1 Manual de usuario descargar pdf (Pagina 107)

Dell PowerConnect W AirWave 7.1 | User Guide Configuring and Using Device Groups in AWMS | 107

Configuring WLANs for Cisco WLC Devices

In Cisco WLC Config, WLANs are based on SSIDs or VLANs that are dedicated to Cisco WLC controllers.

Perform the following steps to define and configure WLANs for Cisco WLC controllers.

1. Navigate to the Group

s > Cisco WLC Config page, and click WLANs in the navigation pane at left. This

page displays the SSIDs or VLANs that are available for use with Cisco WLC devices, and enables you to

define new SSIDs or VLANs. Figure 51 illustrates this page.

2. To change the ID/position of a WLAN on the contro

ller by dragging and dropping, set the toggle to yes. Note

that the by setting this flag to yes, AMP will display a mismatch if the WLANs in the desired and device

config differ only on the order.

Figure 51 Groups

> Cisco WLC Config > WLANS page illustration

3. To add or edit SSIDs or VLANs that are dedicated to Cisco WLC devices,

either click the Add New SSID/

VLAN button, or click the pencil icon for an existing SSID/VLAN. A new page appears comprised of four tabs,

as follows:

 General—Defines general administrative parameters for the Cisco WLC WLAN.

 Security—Defines encryption and RADIUS servers.

 QoS—Defines quality of service (QoS) parameters for the Cisco WLC WLAN.

 Advanced—Defines advanced settings that are available only with Cisco WLC devices, for example, AAA

override, coverage, DHCP and DTIM period.

Note: Refer to Cisco documentation for additional information about Cisco WLC devices and related features.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 333 334

Sin comentarios

Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 107