Dell PowerConnect W-Airwave 7.1 Manual de usuario Pagina 82

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 334
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 81
82 | Configuring and Using Device Groups in AWMS Dell PowerConnect W AirWave 7.1 | User Guide
Editing Columns on the Groups > List Page and Additional Pages
Perform the following steps to edit the columns that appear on the Groups > List page. All additional list and
reports pages in AWMS Version 7.0 and later allow you to edit the presence and sequence of columns in this
manner:
1. Above the list or report, click Edit Columns. The supported columns appear in a popu
p window, as illustrated
in Figure 41:
Figure 41 Edit Columns Illust
ration for the Groups > List Page
2. To remove one or more columns from the G
roups > List page, click to remove the check mark from the
associated checkbox.
3. To change the sequence in which columns ap
pear on the Groups > List page, place your cursor over the drag-
and-drop icon, left click, move the column to the new position, and release.
4. Click Save to retain your settings. The G
roups > List page displays your changes.
The following pages include columns abl
e to be edited for data display:
Home > Search (results)
Helpdesk > Incidents
Groups > List
Groups > Monitor
Groups > Cisco WLC Config
APs/Devices > List
APs/Devices > New
APs/Devices > Up
APs/Devices > Down
APs/Devices > Mismatched
Up/Down Status
Polling Period
Column represents the time between Up/Down SNMP polling periods for each device in the group.
Detailed SNMP polling period information is available on the Groups > Basic configuration page. Note that
by default, most polling intervals do not match the up/down period.
Duplicate Column represents a hyperlink, and the link creates a new group with the name Copy of <Group Name>
with
the same group configuration.
Table 37 Groups > List Page Fields and Default Values (Continued)
Column Description
Note: When you first configure AWMS, there is only one default group labeled Access Points. If you have no other groups
configured, refer to “Configuring Basic Group Settings” on page83.
Vista de pagina 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 333 334

Comentarios a estos manuales

Sin comentarios