
Back to Contents Page
Installing System Components
Dell™PowerVault™NX1950SystemsHardwareOwner'sManual
This section describes how to install the following system components:
l Cooling fan modules
l Cooling shrouds
l Power supplies
l SAS controller daughter card or SAS RAID controller daughter card
l RAID battery
l RAID controller expansion card
l Expansion cards
l Boot drive
l System memory
l Processors
l RAC card
l Optical drive
l Hard drives
l SAS backplane boards
l Risers
l Sideplane board
l System battery
l Control panel assembly
l System board
Recommended Tools
You may need the following items to perform the procedures in this section:
l Key to the system keylock
l #2 Phillips screwdriver
l T10 Torx driver
l Small flat-blade screwdriver
l Wrist grounding strap
Inside the System
Recommended Tools
Inside the System
Removing and Replacing the Front Bezel
Opening and Closing the System
Cooling Fan Modules
Cooling Shrouds
Power Supplies
SAS Controller Daughter Card
Expansion Cards
System Memory
Activating the Integrated NIC TOE
Processors
RAC Card
Optical Drive
Hard Drives
Replacing a Hard-Drive Carrier
Expansion-Card Riser
Backplane Board
Sideplane Board
System Battery
Control Panel Assembly (Service-Only Procedure)
System Board (Service-Only Procedure)
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
CAUTION: The memory modules can become extremely hot during normal operation. Allow the modules sufficient time to cool before handling.
Comentarios a estos manuales