Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 48)

The process for removing a drive blank depends on whether your system is configured with 3.5-inch hard drives.

For 3.5-inch hard drive configurations:



1. Remove the front bezel, if attached. See Removing and Replacing the Front Bezel.



2. Insert your finger under the shrouded end of the blank and press in on the latch to eject the blank outward from the bay.



3. Pry the ends of the blank outward until the blank is free.



Installing a Hot-Plug Hard Drive



1. Remove the front bezel if attached. See Removing and Replacing the Front Bezel.



2. If a drive blank is present in the bay, remove it. See Removing a Drive Blank.



3. Install the hot-plug hard drive.

a. Open the hard-drive carrier handle. See Figure3-17.

Figure 3-17. Installing a Hot-Plug Hard-Drive

b. Insert the hard-drive carrier into the drive bay until the carrier contacts the backplane. See Figure3-17.

c. Close the hard-drive carrier handle to lock it in place.



4. Replace the front bezel if it was removed in step 1. See Removing and Replacing the Front Bezel.

Replacing a Hard-Drive Carrier



Removing a Hard Drive From a Hard-Drive Carrier

To remove a hard drive from a hard-drive carrier, remove the four screws from the slide rails on the hard-drive carrier and separate the hard drive from the

carrier.



Installing a SAS Hard Drive Into a SATAu Drive Carrier

NOTICE: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard-drive carrier and attempting to lock its handle

next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable.

NOTICE: Not all operating systems support hot-plug drive installation. See the documentation supplied with your operating system.

drive carrier release handle

drive carrier

hard drive

NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so can damage the partially

installed carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is fully installed.

NOTE: SAS hard drives must be installed only in SATAu drive carriers. The SATAu drive carrier is labeled "SATAu" and also has marks indicating the SAS

and SATA mounting screws.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)