Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 42)



1. Open the system. See Opening and Closing the System.



2. Remove the memory cooling shroud. See Removing the Memory Cooling Shroud.



3. Locate the memory module sockets. See Figure6-2.



4. Press the ejectors on the memory module socket down and out, as shown in Figure3-12, to allow the memory module to be inserted into the socket.



5. Handle each memory module only on either card edge, ensuring not to touch the middle of the memory module.

Figure 3-12. Installing and Removing a Memory Module



6. Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in the socket.



7. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock the memory module into the socket.

When the memory module is properly seated in the socket, the ejectors on the memory module socket align with the ejectors on the other sockets that

have memory modules installed.



8. Repeat step 3 through step 7ofthisproceduretoinstalltheremainingmemorymodules.SeeTable3-1.



9. Replace the memory cooling shroud. See Replacing the Memory Cooling Shroud.



10. Close the system. See Opening and Closing the System.



11. Press <F2> to enter the System Setup program, and check the System Memory setting on the main System Setup screen.

The system should have already changed the value to reflect the newly installed memory.



12. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat step 1 through step 11 of this procedure, checking to

ensure that the memory modules are firmly seated in their sockets.



13. Run the system memory test in the system diagnostics. See Running the System Diagnostics.



Removing Memory Modules



1. Open the system. See Opening and Closing the System.



2. Remove the memory cooling shroud. See Removing the Memory Cooling Shroud.



3. Locate the memory module sockets. See Figure6-2.



memory module

memory module socket ejectors (2)

alignment key

NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

CAUTION: The memory modules are hot to the touch for some time after the system has been powered down. Allow time for the memory modules

to cool before handling them. Handle the memory modules by the card edges and avoid touching the components on the memory module.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 42

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)