The password jumper enables these password features or disables them and clears any password(s) currently in use.
1. Turnoffthesystem,includinganyattachedperipherals,anddisconnectthesystemfromtheelectricaloutlet.
2. Open the system. See Opening and Closing the System.
3. Lift up the memory module shroud.
4. Remove the jumper plug from the password jumper.
See Figure6-1 to locate the password jumper on the system board.
5. Close the system.
6. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
The existing passwords are not disabled (erased) until the system boots with the password jumper plug removed. However, before you assign a new
systemand/orsetuppassword,youmustinstallthejumperplug.
7. Turnoffthesystem,includinganyattachedperipherals,anddisconnectthesystemfromtheelectricaloutlet.
8. Open the system. See Opening and Closing the System.
9. Install the jumper plug on the password jumper.
10. Lower the memory module shroud.
11. Close the system.
12. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
13. Assign a new system and/or setup password.
To assign a new password using the System Setup program, see Assigning a System Password.
System Board Connectors
See Figure6-2 and Table6-2 for the location and description of system board connectors.
Figure 6-2. System Board Connectors
Comentarios a estos manuales