Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 49)



1. Insert the SAS hard drive into the hard-drive carrier with the connector end of the drive at the rear. See Figure3-18.



2. Viewing the assembly as shown in Figure3-18, align the bottom rear screw hole on the hard drive with the hole labeled "SAS" on the hard drive carrier.

When aligned correctly, the rear of the hard drive will be flush with the rear of the hard-drive carrier.



3. Attach the four screws to secure the hard drive to the hard-drive carrier. See Figure3-18.

Figure 3-18. Installing a SAS Hard Drive Into a Drive Carrier

Expansion-Card Riser



Removing an Expansion-Card Riser



1. If applicable, remove the bezel. See Removing and Replacing the Front Bezel.



2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.



3. Open the system. See Opening and Closing the System.



4. If applicable, remove the expansion card from the riser.



5. Press the release latch(es) on the riser board and lift the riser board straight up from the system board. See Figure3-19.

The left riser board has two release latches; the center riser board has one latch.

Figure 3-19. Expansion-Card Riser Removal

screws (4)

SATAu drive carrier

SAS hard drive

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 49

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)