Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 47)



Installing the Optical Drive Tray



1. Align the optical drive tray with its opening in the front panel.

The optical drive opening is located directly below the SAS daughter card bay.



2. Slide in the drive tray until the tray snaps into place. See Figure3-16.



3. Connect the optical-drive cable from the back of the drive. See Figure3-16.



4. Replace the SAS controller daughter card.See Replacing or Installing a SAS RAID Controller Daughter Card.



5. Close the system. See Opening and Closing the System.



6. Replace the bezel. See Removing and Replacing the Front Bezel.



7. Reconnect your system and peripherals to their electrical outlets, and turn on the system.

Hard Drives

This subsection describes how to install and configure SAS hard drives in the system's internal hard-drive bays. Your system features two 3.5-inch (SAS)

internal hard-drive bays. All drives connect to the system board through one of two optional backplane boards.



Before You Begin

Hard drives are supplied in special hot-pluggable drive carriers that fit in the hard-drive bays.

You may need to use different programs than those provided with the operating system to partition and format SAS hard drives.

When you format a high-capacity hard drive, allow enough time for the formatting to be completed. Long format times for these drives are normal. A 9-GB hard

drive, for example, can take up to 2.5 hours to format.



Removing a Drive Blank

optical -drive tray

optical-drive cable

optical-drive release tab

optical drive



NOTICE: Before you attempt to remove or install a drive while the system is running, see the documentation for the optional SAS RAID daughter card to

ensure that the host adapter is configured correctly to support hot-pluggable drive removal and insertion.

NOTE: It is recommended that you use only drives that have been tested and approved for use with the SAS backplane board.

NOTICE: Donotturnofforrebootyoursystemwhilethedriveisbeingformatted.Doingsocancauseadrivefailure.

NOTICE: To maintain proper system cooling, all empty hard-drive bays must have drive blanks installed. If you remove a hard-drive carrier from the

system and do not reinstall it, you must replace the carrier with a drive blank.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 47

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)