Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 52)



1. If applicable, remove the bezel. See Removing and Replacing the Front Bezel.



2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.



3. Open the system. See Opening and Closing the System.



4. Remove the SAS controller daughter card. See Removing a SAS RAID Controller Daughter Card.



5. Disconnectthecontrolpanelcableandopticaldrivecable(ifapplicable)fromthesideplane.SeeFigure6-3.



6. Press inward on the two sideplane release latches marked in blue and lift the sideplane up and away from the system board.



Installing the Sideplane Board



1. Align the guide on the end of the sideplane board with the pins on the system board, and lower the sideplane until that the sideplane connector is fully

seated into the connector on the system board.



2. Connect the control panel cable and optical drive cable (if applicable) to the sideplane. See Figure6-3.



3. Replace the SAS controller daughter card. See Replacing or Installing a SAS RAID Controller Daughter Card.



4. Close the system. See Opening and Closing the System.



5. Replace the bezel. See Removing and Replacing the Front Bezel.



6. Reconnect your system and peripherals to their electrical outlets, and turn on the system.

System Battery

The system battery is a 3.0-volt (V), coin-cell battery.



Replacing the System Battery



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



2. Open the system. See Opening and Closing the System.



3. If an expansion card is installed in the left riser board, remove the card. See Removing an Expansion Card.



4. Locate the battery socket. See Figure3-21.



CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.

CAUTION: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type

recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See your System Information Guide for

additional information.

NOTICE: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the

object is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board

by prying off the socket or by breaking circuit traces on the system board.

NOTICE: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)