Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario descargar pdf (Pagina 54)

a. Squeeze the metal tabs on the ends of the cable connector.

b. Gently work the connector out of the socket.



f. Disconnect the front panel cable from the control panel board. See Figure3-22.



g. Lift the release tab at the back of the control panel carrier and slide the carrier towards the back of the system, then lift the carrier out of the system.

See Figure3-22.



h. Removethethreescrewsthatsecurethecontrolpanelboardtothecarrierandremovetheboard.SeeFigure3-22.



i. Remove the display module:

a. Insert the end of a paper clip into the hole on the right side of the display module and gently pry the label off.

b. Using a T10 Torx driver, remove the two screws that secure the display module to the system chassis. See Figure3-22.

c. Remove the display module from the chassis cutout.

Figure 3-22. Control Panel Removal and Installation



Installing the Control Panel



NOTICE: Do not pull on the cable to unseat the connector. Doing so can damage the cable.

display module

display module LCD cable

control panel circuit board

control panel

cable

control-panel circuit board securing

screws (3)

control panel carrier release

tab

control panel

carrier

display module label

display module securing

screws (2)

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See

your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against

electrostatic discharge.



1. Insert the display module into the chassis cutout and secure it with the two screws.



2. Affix the control panel label to the display module.



3. Install the control panel board on the carrier, and secure it with the three Phillips screws. See Figure3-22.



4. Install the carrier in the system chassis.



5. Connect the display module ribbon cable to the control panel board.



6. Connect the control panel ribbon cable to the control panel board.



7. Replace the SAS controller daughter card. See Replacing or Installing a SAS RAID Controller Daughter Card.



8. Close the system. See Opening and Closing the System.



1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 80 81

Comentarios a estos manuales

Sin comentarios

Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950)