Dell Microsoft Windows Unified Data Storage Server 2003 (PowerVault NX 1950) El manual del propietario Pagina 50

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 81
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 49
Installing an Expansion-Card Riser
1. Align the riser board with the alignment pins on the system board, then lower the board onto the pins.
2. Press down on the riser board until the edge connector(s) on the board is (are) fully seated in the riser board connector on the system board. See
Figure3-19.
3. If applicable, install the expansion card in the expansion-card slot.
4. Close the system. See Opening and Closing the System.
5. Replace the bezel. See Removing and Replacing the Front Bezel.
6. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
Backplane Board
Removing the Backplane Board
The removal procedure varies slightly, depending on which backplane board you have in your system.
1. If applicable, remove the bezel. See Removing and Replacing the Front Bezel.
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
3. Open the system. See Opening and Closing the System.
4. Remove the hard drives.
1
left riser board
2
left riser board release
latches(2)
3
left riser board alignment
pins(2)
4
left riser board
connectors (2)
5
center riser board
connector
6
center riser board alignment
pins (2)
7
center riser board
8
center riser board release
latch
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
NOTE: To properly reinstall the hard drives, ensure that you record which hard drive you remove from which bay.
Vista de pagina 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 80 81

Comentarios a estos manuales

Sin comentarios