
To convert the interfaces 9 and 10 from Ethernet to Fibre Channel mode, use the
no stack-unit unit number port-group 0 portmode ethernet.
Parameters
stack-unit Enter the keyword stack-unit followed by a stack member
number to select the stack unit. The range is 0 to 5.
port-group Enter the keyword port-group followed by 0.
portmode
ethernet
Enter the keyword portmode ethernet to convert the
interfaces from Fibre Channel mode to Ethernet.
Command
Modes
CONFIGURATION
Command
History
Version 9.6(0.0) Supported on the FN I/O Aggregator.
Usage
Information
The command is supported only in FN2210S Aggregator.
name
Assign a name to the Default VLAN.
Syntax
namevlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-name Enter up to 32 characters as the name of the VLAN.
Defaults Not configured.
Command
Modes
INTERFACE VLAN
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
This CLI applies only to the Default VLAN.
To display information about a named VLAN, enter the show vlan command with
the name parameter or the show interfaces description command.
Related
commands
default vlan-id —Assigns a descriptive text string to the interface.
interface vlan — Configures a VLAN.
show vlan — Displays the current VLAN configurations on the switch.
144
Comentarios a estos manuales