Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 318)

100

101

Commands

dcb-map — creates a DCB map to configure PFC and ETS parameters and applies

the PFC and ETS settings on Ethernet ports.

show stack-unit stack-ports ets details

Displays the ETS configuration applied to egress traffic on stacked ports, including ETS Operational mode

on each unit and the configurated priority groups with dot1p priorities, bandwidth allocation, and

scheduler type.

Syntax

show stack-unit {all | stack-unit} stack-ports {all | port-

number} ets details

Parameters

stack-unit Enter the stack unit identification.

port-number Enter the port number.

Command

Modes

CONFIGURATION

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Example

Dell(conf)# show stack-unit all stack-ports all ets details

Stack unit 0 stack port all

Max Supported TC Groups is 4

Number of Traffic Classes is 1

Admin mode is on

Admin Parameters:

--------------------

Admin is enabled

TC-grp Priority# Bandwidth TSA

------------------------------------------------

0 0,1,2,3,4,5,6,7 100% ETS

1 - -

2 - -

3 - -

4 - -

5 - -

6 - -

7 - -

8 - -

Stack unit 1 stack port all