The starting point for using LLDP is invoking LLDP with the protocol lldp command in either
CONFIGURATION or INTERFACE mode.
The information LLDP distributes is stored by its recipients in a standard management information base
(MIB). You can access the information by a network management system through a management
protocol such as simple network management protocol (SNMP).
For details about implementing LLDP/LLDP-MED, refer to the Link Layer Discovery Protocol chapter of
the Dell Networking OS Configuration Guide.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Parameters
max-frame-
size
Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Defaults none
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {system-capabilities | system-
description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {system-capabilities | system-description | system-name}
command.
Parameters
system-
capabilities
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the LLDP peer.
system-
description
Enter the keywords system-description to advertise the
system description TLVs to the LLDP peer.
system-name Enter the keywords system-name to advertise the system
name TLVs to the LLDP peer.
Defaults none
376
Comentarios a estos manuales