Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 319)

100

101

4 - -

5 - -

6 - -

7 - -

8 - -

show stack-unit stack-ports pfc details

Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational

mode on each unit with the configured priorities, link delay, and number of pause packets sent and

received.

Syntax

show stack-unit {all | stack-unit} stack-ports {all | port-

number} pfc details

Parameters

stack-unit Enter the stack unit.

port-number Enter the port number.

Command

Modes

CONFIGURATION

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Example

Dell(conf)# show stack-unit all stack-ports all pfc details

stack unit 0 stack-port all

Admin mode is On

Admin is enabled, Priority list is 4-5

Local is enabled, Priority list is 4-5

Link Delay 45556 pause quantum

0 Pause Tx pkts, 0 Pause Rx pkts

stack unit 1 stack-port all

Admin mode is On

Admin is enabled, Priority list is 4-5

Local is enabled, Priority list is 4-5

Link Delay 45556 pause quantum

0 Pause Tx pkts, 0 Pause Rx pkts

Dynamic Host Configuration Protocol

Dynamic host configuration protocol (DHCP) is an application layer protocol that dynamically assigns IP

addresses and other configuration parameters to network end-stations (hosts) based on configuration

policies determined by network administrators.

An Aggregator can operate as a DHCP client. As a DHCP client, the Aggregator requests an IP address

from a DHCP server.

319

1 2 ... 314 315 316 317 318 319 320 321 322 323 324 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 319

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s