Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 424)

100

101

| Pipe through a command

<cr>

Dell#show system stack-unit 0 stack-group configured

Configured stack groups in stack-unit 0

Dell#show system stack-unit 0 stack-group

Stack group Ports

------------------------------------

0 0/9

1 0/10

2 0/11

3 0/12

Dell#

Commands

reload— reboots the system.

show system— displays the current status of all stack members or a specific

member.

stack-unit priority

Configure the ability of a switch to become the management unit of a stack.

Syntax

stack-unit stack-number priority 1-14

Parameters

stack-number Enter the stack member unit identifier.

1–14 This preference parameter allows you to specify the

management priority of one backup switch over another,

with 0 the lowest priority and 14 the highest. The switch with

the highest priority value is chosen to become the

management unit if the active management unit fails or on

the next reload.

Defaults 0

Command

Modes

CONFIGURATION

Command

History

Version 9.6.

(0.0)

Introduced on the FN I/O Aggregator.

Usage

Information

This command is supported on the FN410S and the FN410T Aggregators.

Commands

• reload – reboots Dell Networking Operating System (OS).

• show system – displays the status of all stack members or a specific member.

stack-unit renumber

Change the stack member ID of any stack member or a stand-alone unit.

Syntax

stack-unit 0-5 renumber 0-5

424

1 2 ... 419 420 421 422 423 424 425 426 427 428 429 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 424

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s