Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 86)

100

101

u-Boot

All commands in this chapter are in u-Boot mode. These commands are supported on the Dell

Networking Aggregator only.

To access this mode, hit Esc key when the following line appears on the console during a system boot:

Hit Esc key to interrupt autoboot:

You enter u-Boot immediately, as indicated by the BOOT_USER# prompt.

NOTE: Only the most frequently used commands available in uBoot mode are described in this

chapter.

In uBoot mode, you cannot use the Tab key for command completion.

boot change

Change the operating system boot parameters.

Syntax

boot change [primary | secondary | default]

Command

Modes

• uBoot

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator.

boot show net config retries

Show the number of retries for network boot configuration failure.

Syntax

boot show net config retries

Command

Modes

• uBoot

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 86

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s