Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 452)

100

101

Command

Modes

• EXEC

• EXEC Privilege

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Example

Dell#show uplink-state-group detail

(Up): Interface up (Dwn): Interface down (Dis): Interface

disabled

Uplink State Group : 1 Status: Enabled, Up

Defer Timer : 10 sec

Upstream Interfaces : Po 128(Up)

Downstream Interfaces : Te 0/1(Dwn) Te 0/2(Dwn) Te 0/3(Up) Te

0/4(Dwn) Te 0/5(Up)

Te 0/6(Dwn) Te 0/7(Up) Te 0/8(Up)

Dell#

Commands

• show running-config uplink-state-group — displays the current configuration

of one or more uplink-state groups.

• uplink-state-group — create an uplink-state group and enables the tracking of

upstream links.

uplink-state-group

Create an uplink-state group and enable the tracking of upstream links on a switch/ router.

Syntax

uplink-state-group group-id

To delete an uplink-state group, enter the no uplink-state-group group-id

command.

Parameters

group-id Enter the ID number of an uplink-state group. The range is

from 1 to 16.

Defaults none

Command

Modes

CONFIGURATION

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Usage

Information

After you enter the command, to assign upstream and downstream interfaces to

the group, enter Uplink-State-Group Configuration mode.

An uplink-state group is considered to be operationally up if at least one upstream

interface in the group is in the Link-Up state.

452

1 2 ... 447 448 449 450 451 452 453 454 455 456 457 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 452

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s