Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 145)

100

101

negotiation auto

Enable auto-negotiation on an interface.

Syntax

negotiation auto

To disable auto-negotiation, enter no negotiation auto command.

Defaults Enabled.

Command

Modes

INTERFACE

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator.

Usage

Information

The no negotiation auto command is only available if you first manually set

the speed of a port to

10Mbits or 100Mbits.

Example

(Configured)

Dell#show interfaces configured

TenGigabitEthernet 0/1 is up, line protocol is up

Hardware is DellEth, address is 00:1e:c9:de:04:9c

Current address is 00:1e:c9:de:04:9c

Server Port AdminState is N/A

Pluggable media not present

Interface index is 33886978

Internet address is not set

Mode of IPv4 Address Assignment : NONE

DHCP Client-ID :001ec9de049c

MTU 12000 bytes, IP MTU 11982 bytes

LineSpeed 10000 Mbit

Flowcontrol rx on tx off

ARP type: ARPA, ARP Timeout 04:00:00

Last clearing of "show interface" counters 03:56:48

Queueing strategy: fifo

Input Statistics:

User

Information

Both sides of the link must have auto-negotiation enabled or disabled for the link

to come up.

The following details the possible speed and auto-negotiation combinations for a

line between two 10/100/1000 Base-T Ethernet interfaces.

Port 0

• auto-negotiation enabled* speed 1000 or auto

• auto-negotiation enabled speed 100

• auto-negotiation disabled speed 100

• auto-negotiation enabled* speed 1000 or auto

Port 1

• auto-negotiation enabled* speed 1000 or auto

• auto-negotiation enabled speed 100

145

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 145

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s