Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 422)

100

101

Commands

power-cycle stack-unit—resets the designated stack member.

show diag— displays the data plane or management plane input and output

statistics of the designated component of the designated stack member.

show system—displays the current status of all stack members or a specific

member.

stack-unit iom-mode

Toggle the FN I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and

VLT modes.

Syntax

stack-unit <unit-number> iom-mode [programmable-mux | stack |

standalone | vlt]

Parameters

unit number

<0-5>

Enter the number of the member stack unit. The range is

from 0 to 5.

programmable

-mux

Enable programmable multiplex mode.

stack Enable stack mode.

standalone Enable stand-alone mode.

vlt Enable virtual link trunking mode.

Defaults standalone

Command

Modes

• CONFIGURATION

Command

History

Version 9.6.

(0.0)

Supported on the FN I/O Aggregator.

Usage

Information

This command is supported on the FN410S and the FN410T Aggregators.

Example

Dell(conf)#stack-unit 0 iom-mode stack

% You are about to stack your IOA module, please reload the IOA

and then plug in the stacking cable for the changes to take

effect.

Dell(conf)#

Dell#

Commands

reload— Reboots the operating system.

show system— displays the current status of all stack members or a specific

member.

422

1 2 ... 417 418 419 420 421 422 423 424 425 426 427 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 422

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s