Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 296)

100

101

advertise dcbx-tlv

On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.

Syntax

advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-

reco | pfc] [ets-conf | ets-reco | pfc]

To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.

Parameters

{ets-conf | ets-

reco | pfc}

Enter the PFC and ETS TLVs advertised, where:

• ets-conf: enables the advertisement of ETS

configuration TLVs.

• ets-reco: enables the advertisement of ETS

recommend TLVs.

• pfc: enables the advertisement of PFC TLVs.

Defaults All PFC and ETS TLVs are advertised.

Command

Modes

PROTOCOL LLDP

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Usage

Information

You can configure the transmission of more than one TLV type at a time; for

example: advertise dcbx-tlv ets-conf ets-reco.

You can enable ETS recommend TLVs (ets-reco) only if you enable ETS

configuration TLVs (ets-conf). To disable TLV transmission, use the no form of

the command; for example,

no advertise dcbx-tlv pfc ets-reco.

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the

switch. To verify the DCBX configuration on a port, use the show interface

dcbx detail command.

clear dcbx counters

Clear all DCBx TLV counters on an interface.

Syntax

clear dcbx counters tengigabitethernet slot/port

Defaults none

Command

Modes

EXEC Privilege

296

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 296

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s