Dell PowerEdge FX2/FX2s Manual de usuario descargar pdf (Pagina 438)

100

101

NOTE: For v1 / v2c trap configuration, if the community-string is not defined

using the snmp-server community command prior to using this command,

the default form of the snmp-server community command automatically is

configured with the community-name the same as specified in the

snmp-

server host command.

Configuring Informs

To send an inform, use the following steps:

1. Configure a remote engine ID.

2. Configure a remote user.

3. Configure a group for this user with access rights.

4. Enable traps.

5. Configure a host to receive informs.

Commands

snmp-server enable traps — enables SNMP traps.

Syslog Commands

The following commands allow you to configure logging functions on all Dell Networking switches.

clear logging

Clear the messages in the logging buffer.

Syntax

clear logging

Defaults none

Command

Modes

EXEC Privilege

Command

History

Version 9.4(0.0) Supported on the FN I/O aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Commands

show logging — displays logging settings and system messages in the internal

buffer.

logging

Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple

logging servers of both IPv4 and/or IPv6 can be configured.

Syntax

logging {ip-address | ipv6-address | hostname} [vrf vrf-name]

To disable logging, use the no logging command.

Parameters

ip-address Enter the IPv4 address in dotted decimal format.

ipv6-address Enter the IPv6 address in the x:x:x:x::X format.

438

1 2 ... 433 434 435 436 437 438 439 440 441 442 443 ... 461 462

Comentarios a estos manuales

Sin comentarios

Dell PowerEdge FX2/FX2s Manual de usuario Pagina 438

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Dell PowerEdge FX2/FX2s